TCL 30805-000149 Power Supply Board – Common Failures, Symptoms & Proper Repair Solution
Share
The TCL 30805-000149 power supply board is used in several TCL LED TVs and is a known failure point when backlight issues are present. One of the most important things to understand about this board is that the power supply and backlight are directly related. Replacing or repairing one without addressing the other often leads to repeat failure.
In this article, we’ll explain the most common symptoms, why this board fails, and the correct way to fix the TV—based on real-world repair experience.
TVs That Use the TCL 30805-000149 Power Supply Board
This power supply is found in select TCL LED TV models. Always confirm the exact board number printed on the PCB, as TCL often uses similar-looking boards with different revisions.
⚠️ Matching the board number is critical to avoid compatibility issues.
Common Symptoms of Failure
When the 30805-000149 power supply board begins to fail, the TV may show one or more of the following symptoms:
- TV will not turn on
- TV turns on briefly, then shuts off
- No backlight but sound is present
- TV clicks repeatedly and never starts
- Power supply fails again after replacement
These symptoms are frequently misdiagnosed as a bad power board alone, when the real issue includes the backlight system.
Why the TCL 30805-000149 Power Supply Fails
This power supply commonly fails as a result of defective or aging LED backlights.
When the backlight strips degrade or short internally, they place excessive stress on the power supply’s backlight circuit. Over time, this overload causes damage to components on the power board—leading to repeated shutdowns or complete failure.
Key point:
Replacing the power supply without replacing the backlight will cause the new or repaired power supply to fail again.
Known Component Failure: Diode D601
For technicians attempting component-level repair, there is a known weak point on this board:
- Component: Diode
- Location: D601
- Position: Next to the backlight connector on the power supply board
When the backlight is defective, diode D601 often fails due to excessive current load. Replacing this diode can restore the power supply only if the backlight problem is corrected at the same time.
⚠️ Replacing D601 without replacing the defective backlight will result in repeat failure.
Can the Power Supply Be Repaired Instead of Replaced?
Yes — but only under specific conditions.
Power supply repair may be successful if:
- Diode D601 is replaced
- The LED backlight strips are tested and replaced
- No additional power board damage is present
However, component-level repair requires:
- Proper diagnostic tools
- Backlight testing equipment
- Soldering experience
For most users and repair shops, full board replacement combined with backlight replacement is the most reliable and time-efficient solution.
The Correct Repair Solution (Important)
To properly fix a TV using the TCL 30805-000149 power supply board, both components must be addressed:
✅ Replace the power supply board
✅ Replace the LED backlight strips
If the backlight is not replaced, the power supply will continue to fail, even if it’s brand new or has been repaired.
👉 Recommended replacement:
TCL 30805-000149 Power Supply Board
Installation & Safety Notes
- Always unplug the TV before servicing
- Power supply boards store high voltage
- Match the board number exactly
- Test LED backlights before powering the TV fully
If you are unsure about handling high-voltage electronics, professional service is recommended.
Conclusion
The TCL 30805-000149 power supply board does not typically fail on its own; it is most often damaged by defective LED backlights. This is why replacing or repairing the power supply alone leads to repeat failures.
For a successful, long-lasting repair:
- Replace the backlight strips
- Replace or properly repair the power supply
- Address diode D601 only if backlight issues are corrected
Understanding this relationship saves time, money, and prevents unnecessary repeat repairs.